Powering ON the Bike
- Flip up the kickstand, squeeze the brake lever to engage the brakes and kick your leg over the saddle.
- When firmly seated on the bike, press the handlebar control power button to turn the bike on.
NOTE: The control power button needs to be pressed (2-3 seconds) to start-up/ power down.
|
|
NEVER SIT ON THE BIKE WITH THE KICKSTAND ENGAGED. |
|
|
WARNING ONCE THE DISPLAY SCREEN IS ILLUMINATED, THE THROTTLE AND PEDAL ASSIST IS LIVE. DO NOT TOUCH THE CHAINS, CHAINRINGS, MOTOR, COG, WHEELS, OR ANY MOVING PARTS WHILE THE MOTOR IS ACTIVATED. |
Click HERE to learn about your battery on page 10.
Display Set Up
Before riding, double check the basic display settings.
-
Turn on display & double press the Menu button to activate the settings menu.
a. Press the Power button to enter basic settings menu -
Select ‘Wheel’, then press the Menu button to select the wheel size
a. Make sure the 303FS wheel size is set to ‘29 inch’ (for 26” fat tire diameter)
b. This will ensure accurate speedometer readings -
Select ‘Battery’, then press the Menu button to select voltage setting
a. Make sure the 303FS battery voltage is set to ‘52 V’
b. This will ensure accurate battery capacity level readings -
Press Menu again to set the changes and Exit the settings navigation:
Powering OFF the Bike
It is important to turn off the power properly when you are finished riding.
- Press and hold the power button on the display.
- The display will turn off when properly powered down.
